[ntp:questions] Re: Servers just doen't work (after following the troubleshooting page)
S P Arif Sahari Wibowo
arifsaha at yahoo.com
Tue Sep 27 17:18:53 UTC 2005
On Tue, 27 Sep 2005, Ronan Flood wrote:
> S P Arif Sahari Wibowo <arifsaha at yahoo.com> wrote:
>> <server1.int.ip> 0.0.0.0 16 u - 256 0 0.000 0.000 4000.00
>
> I note you use server1.int.ip here, but server1.ip or
> ntp1.mydomain elsewhere -- is that significant?
My bad! It should be <server2.int.ip> (the internal IP of
server2).
ntp1 and ntp2 both point to internal IP of server1 and server2,
respectively. So ntp2 will be the same IP address as
<server2.int.ip>.
> "ntpq -np" will show the IP addresses in use, rather than
> reverse translating them back to names.
Yes I did that too. There were no problem (ntp1 become
<server1.int.ip> and ntp2 become <server2.int.ip>). I used ntp1
and ntp2 because I thought it probably easier to discuss it.
Thanks!
--
Stephan Paul Arif Sahari Wibowo
_____ _____ _____ _____
/____ /____/ /____/ /____
_____/ / / / _____/ http://www.arifsaha.com/
More information about the questions
mailing list