[ntp:questions] ntp# pid 1012 (ntpd), uid 0: exited on signal 11

Hal Murray hal-usenet at ip-64-139-1-69.sjc.megapath.net
Fri Dec 10 06:04:02 UTC 2010


In article <idpmi8$ll9$1 at speranza.aioe.org>,
 "Edward T. Mischanko" <etm1962 at hotmail.com> writes:
>ntpd not working on a Soekris NET4501 with a nanoBSD install.  Any ideas 
>where to start?  ntpdate is working OK. 

signal 11 is segmentation fault (illegal address) so something
is really screwed up.

Lots of people run ntpd on NET4501s so it's probably something simple.

What version of ntpd are you running?  Was it compiled for your OS?

Have you looked in /var/log/messages and such?


There is a -d switch to ntpd.
  http://www.eecis.udel.edu/~mills/ntp/html/ntpd.html

I think it disables switching to daemon mode so the debugging
printout goes to your terminal.


-- 
These are my opinions, not necessarily my employer's.  I hate spam.




More information about the questions mailing list