[ntp:questions] got the Sure GPS on order, how do I program it

Richard B. Gilbert rgilbert88 at comcast.net
Tue Mar 6 20:11:27 UTC 2012

On 3/5/2012 10:04 PM, Ron Frazier (NTP) wrote:
> Hi all,
> OK, I went and ordered the Sure GPS board, cables, box, hardware, etc. I
> even bought a cheapie soldering station for $ 20. Other than the
> mechanical setup which I can figure out and the patches which David
> Taylor has documented, I need to know how to program the unit when it
> comes.
> Specifically, can someone tell me how to:
> * change the baud rate
> * change which sentences are output
> * change the update interval
> * enable waas, if that matters for timing
> * set fixed location mode, if available
> * restore nav mode
> * do a warm restart
> * do a cold restart
> * do a reset to factory defaults
> * save the settings to flash or backup memory so I don't lose them when
> it's powered off
> * if possible, output only the GPZDA sentence
> * Any other magic you think I should know.
> The manual seems to be missing most of these details. As always, any
> help is appreciated. Thanks in advance.

The fact that the manual is missing details could be explained in at 
least two ways:
1. You can't change the baud rate, select sentences, etc, etc.
2. The author of the manual thinks the "how to" is obvious!

Good luck.  I'm afraid the you will need it!

More information about the questions mailing list