[ntp:security] difference between lassociations and associations
Danny Mayer
mayer at pdmconsulting.net
Wed Feb 10 02:31:09 UTC 2016
Ashish,
Please enter a bug report on this. You will find our bug reporting
system here: http://bugs.ntp.org/
The security email is meant to report security issues. You can also ask
questions on either hackers or the questions mailing list.
Thanks,
Danny
On 2/9/2016 1:24 PM, ashish jaiswal wrote:
>
> Hi All,
>
> This is regarding NTPQ command .
>
> when i run ntpq >lassociations and ntp> associations command , i am
> getting a same output  but when i check a ntpq man page . it is give a
> following line.
>
> lassociations
> Obtains and prints a list of association identifiers and peer statuses
> for all associations for which the server is maintaining state. This
> command differs from the associations command only for servers which
> retain state for out-of-spec client associations (i.e., fuzzballs). Such
> associations are normally omitted from the display when the associations
> command is used, but are included in the output of lassociations[char46]
>
> associations
> Obtains and prints a list of association identifiers and peer statuses
> for in-spec peers of the server being queried.
>
> I have  tried a to find a difference between in-spec and out -of-spec
> client associations  but i didnt get it.
>
> Could someone clarify difference between in-spec and out -of-spec client
> associations ?
>
> Thanks in advance .
>
>
>
> # ntpq -c las
>
> ind assid status  conf reach auth condition  last_event cnt
> ===========================================================
>  1 55207  963a  yes  yes  none  sys.peer   sys_peer  3
> # ntpq -c as
>
> ind assid status  conf reach auth condition  last_event cnt
> ===========================================================
>  1 55207  963a  yes  yes  none  sys.peer   sys_peer  3
> # ntpq -p
>    remote      refid    st t when poll reach Â
> delay  offset  jitter
> ==============================================================================
> *PEER       LOCAL(0)     6 u  118  256  377 Â
> Â 0.863 Â -29.660 Â 6.299
>
> ----------------------------
>
> cat ntp.conf :
>
> server 16.213.145.226
> enable mode7Â
>
>
> Thanks and Regards
> Â
> Ashish Jaiswal
>
>
> _______________________________________________
> security mailing list
> security at lists.ntp.org
> http://lists.ntp.org/listinfo/security
>
More information about the security
mailing list